1.A connecting hyperlink of an O-ring Chain for basic application is pre-coated with grease at the pins. Just before connection, confirm the grease to the surfaces of pins, and if your volume of grease is smaller, apply grease with bare hands. (If gloves are utilized, the grease will likely be absorbed by the gloves.)
Example: Once the connecting website link (I) of an O-ring chain for general application is
shipped, O-rings are fitted on the roots with the pins. If the O-rings come loose as a consequence of vibration for the duration of transport, refit the O-rings in to your roots in the pins.
In this case, you should definitely return the grease collected at the roots from the pins to your central surfaces from the pins, additional at portion A than at portions B shown while in the above illustration. (Portions A is worn on account of sliding together with the bushings.)
two.The chain can be most quickly connected over the teeth of a sprocket. Engage the links at both ends in the chain with all the sprocket teeth and match connecting pins. If the sprocket can be moved, the chain can also be linked to the loosened side.
3. Connecting procedure
one.Confirm that O-rings are attached for the roots in the pins.
two.Should the volume of grease utilized over the connecting pins is modest, coat the pins with grease with the central portions.
three.Insert the connecting pins into the bushings with the inner backlinks at both ends.
four.Verify the grease is applied on the whole face of your O-ring, and match the O-ring onto the connecting pins.
5.Insert the connecting pins to the connecting plate and when pressing the connecting plate, install the spring clip. Confirm irrespective of whether the head (the finish with no split) with the spring clip is turned within the feeding path on the chain. (See the following illustration.)
six.Be sure to verify the spring clip is securely fitted within the clip grooves of your connecting pins.
This completes jointing of your connecting website link. Note that grease on the surfaces of connecting pins and O-rings can be eliminated throughout installation operate. In this case, re-grease employing the grease over the surface of the base chain or the grease inside the polyethylene bag during which the connecting link was contained.